Wincor Nixdorf BEETLE AT COM Board Manual do Utilizador descarregar pdf (Página 28)

22 BEETLE /M-II plus (BOS) User Manual

D- Sub- Jack Power Supplied (COM2*-COM4*)

The interface connection is a 9-pin D-sub jack for scanner, user or customer

displays without own power supply.

Make sure that the connector for a peripheral device is screwed

firmly to the socket to prevent possible malfunctioning. Power is

supplied via this jack.

RJ10/RMT Jack (optional)

You connect the remote (RMT) interface of your POS system via a cable to

the RMT interface of the display (BA8X). You use the RMT function by

pushing the ON/OFF button of the display.

The Remote On/Off function (RMT) enables you to wake up a BEETLE

system out of either standby/ hibernation or soft-off mode. It also puts a run-

ning system into standby / hibernation mode. The activated mode is depend-

ing on the settings of the operating system.

USB (Universal Serial Bus)- A

You can connect several USB peripheral devices e.g. scanner or scales to

the USB.

Only connect devices equipped with a shielded cable to the USB-

interface.

P-USB (PoweredUSB)

The P-USB interface is qualified for connections of peripheral devices such

as printers, barcode scanners or customer displays.

The power supply is either 12V or 24V (marked red, for POS printers).

A mechanical code avoids the plugging of a USB 12V connector into a USB

24V jack.

Always use the onboard P-USB 12V (*) to connect a BA82 or BA83

with additional options or any other multifunctional screens.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 51 52

Sem comentários

Wincor Nixdorf BEETLE AT COM Board Manual do Utilizador Página 28